Hammer Header Male - Solderless Raspberry Pi Connector

If your soldering isn't quite up to scratch, or you just don't own a soldering iron yet, these hammer headers from Pimoroni might be just what you need.

Absolutely no soldering required! All that's needed is a few gentle taps with a hammer and whammo! Your header is securely attached to your Pi Zero, Bonnet, HAT or pHAT. Make sure to carefully read Pimoroni's guide for fitting hammer headers.

The socket headers are simpler to insert than the male headers as you can hammer straight onto the plastic of the header, but these plug-headers can be particularly tricky. They are best as an add-on to the hammer-header jig and pack.

Note: Hammer at your own risk! We can't be held responsible for any damage that you may cause to your Pi Zero, bonnet, pHAT, HAT, headers, or fingers while fitting them. If you follow Pimoroni's guide carefully, you should be fine. If this worries you, then get yourself a soldering iron instead!

Features

• No soldering required
• Compatible with Raspberry Pi Zero, Bonnet, HAT or pHAT
• Easy installation with hammer taps
• Best used with hammer-header jig and pack

Technical Details

• Dimensions: 50mm x 5mm x 12mm (1.9" x .7" x .4")
• Pin length: 4mm
• Weight: 2.3g